First check the voltage feed to the Mass Air Flow (MAF) sensor. This should read between 12 and 14.8 volts at idle. At idle, the failed resistor was sending 16 volts to the MAF. This truck is a 24-volt system fitted with a 12-volt MAF. 16 volts is too high for a 12-volt system and too low for a 24-volt system. There are two ways to accomplish this: Run on the highway for a long period of time (>60km/hr) or perform a forced parked regeneration. Moderate Soot Load: If your DPF indicator light is flashing yellow, driving at highway speed is no longer enough. When this happens, you must pull over and perform a parked regeneration. After last dealer visit my truck runs very well. I do not know how long it will run like this. I expect I have to clean the DPF at some point and I want to get all the information and keep in file. My truck is 2007 320 CDI has 108,000 miles. Based on what I know DPF should last ~250,000 miles? Prior to clean up unless it is damaged. vehicle when a DPF regeneration is required based on engine run time, fuel consumed and distance traveled since the last DPF regeneration. 1. Perform the Diagnostic System Check - Vehicle. 2. Is DTC P2463 set? ⇒ If DTC P2463 is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle in SI. After following The company's DPF is built to last and has been around for over 80 years. In order to regenerate a DPF in a truck, you should use a diagnostic scanner. These tools enable you to erase fault codes and graph live data. They work on all Peterbilt trucks, and you can use them for everything from forced DPF regeneration to oil light resets. Press and hold the regeneration button for a few seconds, until the regen warning light goes off and the regen process light starts to blink. Wait for the process to finish, about 30 to 40 minutes. During the regen process, the engine will idle higher as the RPMs are increased, and there will be a burning smell as particulates are incinerated. With Stay Warm, the engine stays warm long enough for the active regeneration to complete. After just a year of launching the Stay Warm feature, school districts are seeing up to a 75-percent decrease in aftertreatment-related issues, while other school districts now have zero DPF-related maintenance issues. Hello, I bought my first TDI in December 2020. It’s a 2010 Passat B6 BlueTDI (German model, with DEF/Adblue system, 2.0TDI) and I am wondering how long my particulate filter can hold up until it hast to be cleaned or replaced. Depending on the driving it needs to regenerate every 300km to 800km. The more I drive in the City, the more often it Vay Tiền Trả Góp Theo Tháng Chỉ Cần Cmnd.

how long does a dpf regeneration last